Lotro Housing Decorations, Mullen Automotive And Apple, Articles D

(11) Markings. The air vent may be combined with the fill-pipe cap or safety vent, or it may be a separate unit installed on the fuel tank. But, confusion arises for diesel in first determining if it is regulated or not. This is a requirement by law and if its not labeled, you will be liable for any damages. If you would like to comment on the current content, please use the 'Content Feedback' button below for instructions on contacting the issuing agency. 800-727-5257. The details of the DOT 406 specification can be found in 49 CFR 178 sub-parts 345 and 346. When the float is immersed in fuel, the float (valve) closes, effectively preventing fuel leakage in the event of a rollover. 2 Diesel Fuel and Jet-A/Jet Fuel BUT IS NOT REQUIRED per Special Provision B1 found in 49 CFR 172.102, p. 325 noted in the Hazardous Materials Table found in 49 CFR 172.101. At least four full threads must be in engagement in each fitting. The Motor Carrier Safety Planner - Transportation Navigate by entering citations or phrases (eg: 1 CFR 1.1 49 CFR 172.101 Organization and Purpose 1/1.1 Regulation Y FAR). To the extent applicable, fueling operations for liquefied gas fuels shall also comply with paragraph (a) of this section. Failure to send ATTA, Inc. retesting documentation within the 2.5 year limit will void ATTA, Inc. manufacture warranty. (8) Safety venting system. 49 CFR 180.413 - LII / Legal Information Institute Our split tanks are designed for transporting and refueling two separated liquids legally on your flat bed or in the bed of your pickup truck. 49 CFR CH.III 7.4.5. Transfer Flow refueling tanks meet or exceed the testing and certification requirements specified in 49 CFR 178.803. Leaking containers shall not be used. Additionally, fabric must be free from scoring which may render the IBC unsafe for transport. The DOT has issued Transfer Flow DOT Special Permit SP-11911 to manufacture and sell refueling tanks that can store gas, diesel, ethanol, methanol, kerosene and aviation fuel. The Two- 2 bungs allow for reversing the fuel fill cap and fuel transfer pump to the side you prefer best. 82-4-3i - 82-4-3i - Parts and accessories necessary for safe operation. Portable containers shall be metal, have tight closures with screw or spring covers and shall be equipped with spouts or other means to allow pouring without spilling. Tanks of this nature can hold large supplies of fuel, for up to weeks or even months. Equipment shall be refueled only at designated locations. 49 CFR 173.32 - Requirements for the use of portable tanks. The fuel tank body must have flanges or spuds suitable for the installation of all fittings.